Hi,
the majority of our outbound goods is on full pallets. With the WMS (CU9) I have the location directives, work template, work classes, and Mobile device menus set up and everything works fine. Except if it comes to full pallet picks. The location directive follows the unit conversions and pulls from location with only full pallets, but when it comes to work and the mobile device I have some doubts that I have everything set up correctly
We store everything in eaches. The sample is a pallet where 1 plt= 8ea. A sales order is typically entered in 48 ea.
After releasing the warehouse and creating my wave and work I get the below.
Image may be NSFW.
Clik here to view.
I get one work line for 6 plt (=48 ea). When opening the work on the mobile device the totals I get is 1 pick with a qty of 48.
When moving further the pi screen asks for the LP (on the bottom I see 6 plt, 48 ea.). After Ok I have to enter the next LP (at this time the LP from the first pick becomes the Target license plate).
At that point I would have to load already two full pallets onto my equipment with even knowing where to go.
This continues until I looped trough all 6 plts to get the final drop off location.
I have the suspicion I am missing either q work break or a different setting on my work template (currently a simple pick and put)
Any thoughts?
Thanks!
