Hi all,
I have an environment of AX2012R2 CU7 with around 1000 assets created but not acquired. The FA module isn't currently in use. The initial FA groups were set up with 2 different value models assigned to them, but I don't want to use either of them.
I have set up a new value model which I want all the Assets to adopt, however my understanding is that each FA picks up all it's 'settings' from the FA Group at the time of creation, so any changes I make later are not applied retrospectively.
I have tried the 'change fixed asset group' for an asset to a new FA group with the correct set up, but this doesn't work, the old value models remain attached to the FA.
Is there any way I can apply changes or refresh the assets already created to pick up new settings to the FA group and value models?
Just testing at the minute, but I cannot see how I can change parameters and settings etc to get the preferred results if any changes only apply to new assets, not the 1000 existing ones.
any ideas anyone please?